Use Of Standard And Clinical Probe System; At235 Stand-Alone Operation; At235 Stand-Alone Operation Panel - Interacoustics AT235 Mode D'emploi

AT235 Instructions for Use - EN

3.4 Use of standard and clinical probe system

For establishing most stable measurements it is recommended not to hold the probe between fingers during
the measurements. Particularly acoustic reflex measurements could be affected by probe movements.

3.5 AT235 Stand-alone operation

3.5.1 AT235 Stand-alone operation panel

Name
1 ON
2 Shift
3 Setup
4-13 Function keys
14 Tests
15 New Session
16 Clients
17 Save
18 Print
19 Wheel
20 Tymp
Description
Turns the AT235 ON and OFF.
Shift is used to access secondary functions of the other keys.
Hold down Setup and use the wheel (19) to select the desired
Setup menu then let go of the Setup button to open it.
The 10 function keys hold functions of which labels are displayed
in the screen.
Hold down Test and use the wheel (19) to select the desired
protocol or audiometry or impedance module. Let go of the Test
button to make your selection.
Clears data and starts a new session in the current module.
Press the Clients button to open a window in which a client can
be selected, edited or created. Also its historic sessions can be
viewed.
Saves the current session for the current module.
Prints the session that is currently on screen.
Used for manual pump control as well as scrolling through menus
and selection possibilities. In the audiometry module the wheel
controls the stimulus intensity.
Selects or deselects a tympanogram test from the protocol.
Page 16