Canon imageFORMULA DR-M160 Guide De Référence page 36

0-00-DR-M160_RG_US.book Page 35 Friday, June 10, 2011 5:31 PM
2
Enter the job name, and press the Enter key.
Hint
Job numbers up to 9 are added (in numerical order) to the end of
the set job name. By specifying the job number with the operating
panel, you can start scanning after pressing the operating panel
button. (See p. 37)
3
Specify the output method of the job. (See p. 40)
4
Click [Output settings], and configure the output settings.
The output setting items differ depending on the specified output
method. For details on the setting items, see the Help of
CaptureOnTouch.
Selecting a Job and Scanning
1
Place the document in the scanner. (See p. 28)
The top screen of Select Scan Job appears.
2
Click a job.
Hint
• If you set [Check output after scanning] to [ON], you can check
the output settings after scanning.
• If you set [Enable continuous scanning] to [ON], you can
continue to scan additional documents after all the pages of the
initial document are scanned.
35