Faq (Frequently Asked Questions) - Comunello AIRWIN A45 230VAC Mode D'emploi

8. FAQ (frequently asked questions)

Question
The actuator is not
operating
The actuator is not
travelling the distance
required
The actuator pulls out the
screws
16
Cause
No voltage supply
With voltage supplied
The window opening is not
as required
Fixings (bottom-hung
window and/or top-hung
window) are no longer
fastened to the frame
Remedy
Check the electrical cut-out or safety
switch is "On".
A cable may not be connected. With
voltage supplied | Check the actuator
voltage corresponds to voltage supply
detected.
Check the actuator voltage corresponds
to voltage supply detected
Detach the rack from the fixing and
check that the limiting arm allows the
actuator to travel the complete run. If this
does not happen, adjust the limiting arm
so that the actuator travels the whole
distance..
Check that suitable fixings have been
used.
Check that, on closing, the rack is
perfectly perpendicular to the frame. If
not, check that the fitting was carried out
according to the Installation Sequence,
5.1.