Miele STB 201 Mode D'emploi page 13

,
Always disconnect the vacuum
cleaner from the electrical supply for
cleaning and maintenance work on
the Turbobrush. Switch off at the
wall socket and remove the plug.
Removing threads and hairs
^ Cut any threads or hairs that have
become entangled on the roller brush
with a pair of scissors. Then run the
vacuum cleaner to vacuum up the
bits.
For more obstinate tangles or blockages
inside the Turbobrush, the cover can be
opened. Any large particles can then be
easily removed.
^ Loosen the locking screws on the
underside of the brush with a coin
and take off the roller cover.
^ Remove any dirt in the brush
compartment interior and from the
roller brush.
^ Put the roller cover back on and
close it.
^ Tighten the locking screws.
en - Cleaning and care
13