8.1 Operation via remote control
Once the green LED (17) lights up, the heating
process of the fog machine is completed: The
unit is ready to produce fog .
12
–
+
INTERVAL
13
14
15
TIMER
8.1.1 Manual mode
To manually activate a fog output, press the
green button MANUAL (19): While this button
is kept pressed, the unit will produce the maxi-
mum quantity of fog .
The manual mode will take priority over the
continuous mode and the timer mode, i . e . when
the green button is pressed, the unit will always
produce the maximum quantity of fog even if
one of the other operating modes is activated .
8.1.2 Continuous mode
In the continuous mode, the unit will produce
fog continuously .
1) To activate the continuous mode, press the
red button CONT (18) so that it will engage
and the red LED (14) above the button will
light up .
2) With the control VOLUME (16), adjust the fog
output quantity from 0 – 100 % .
3) To deactivate the continuous mode, disen-
gage the red button .
The continuous mode will take priority over the
timer mode, i . e . when the red button is pressed,
the unit is set to continuous mode even if the
timer mode has been activated with the button
TIMER (15) .
14
16
–
+
VOLUME
17
18
19
CONT.
MANUAL
8.1.3 Timer mode
In the timer mode, the fog machine will auto-
matically produce fog in adjustable intervals of
5 to 140 seconds . The fog output times are just
as long as the pauses .
1) To activate the timer mode, press the yellow
button TIMER (15) so that it will engage and
the yellow LED (13) above the button will
light up .
2) With the control INTERVAL (12), adjust the
intervals between the individual fog outputs .
3) With the control VOLUME (16), adjust the fog
output quantity from 0 – 100 % .
4) To deactivate the timer mode, disengage
the yellow button; the LED above it will be
extinguished .
8.2 DMX mode
After heating up (approx . 4 minutes after switch-
ing on), the fog machine is ready to produce fog .
Hint: To visually indicate that the unit is ready to
produce fog, the remote control provided
can be connected to the jack REMOTE
CONTROL ONLY (8): once the heating
process is completed, the green LED (17)
will light up .
1) Switch on the DMX controller .
2) On the DMX controller, adjust the desired
DMX value for the channel used to control
the fog machine .
DMX Value
Function
0 – 7
no fog output
8
minimum fog output
255
maximum fog output
Note: In the DMX mode, the fog machine cannot be
operated via remote control .