Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION............................................................ 2
SAFETY..........................................................................4
ASSEMBLY.................................................................... 9
OPERATION.................................................................14
Owner responsibility
WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breath), including chronic bronchitis, silicosis
and pulmonary fibrosis from exposure to
silica. These diseases may be fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
WARNING: Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Make sure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use the
Vac unit.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
•
The products's safety instructions.
•
The products's range of applications and limitations.
•
How the product is to be used and maintained.
National legislation could regulate the use of this
product. Find out what legislation is applicable in the
2
Contents
MAINTENANCE............................................................20
TECHNICAL DATA.......................................................23
US WARRANTY STATEMENT.................................... 24
INTRODUCTION
place where you work before you start using the
product.
Product description
K 4000 is a high speed handheld power cutter designed
to cut hard materials like masonry or steel. It should not
be used for any purpose not described in this manual.
Safe operation of this product requires the operator to
read this manual carefully. Ask your dealer or
Husqvarna if you need more information.
Design and features
Features
K 4000 is made with innovative technology for high
performance and reliability, and provides advanced
technical solutions and environmental considerations.
Some of the unique features of K 4000 are described
below.
Elgard
Elgard
protects the motor. The protection spares the machine
and extends its service life. With the help of Elgard
the machine indicates when it approaches maximum
load.
Softstart
Softstart
a softer start.
Vac attachment accessory (not supplied)
The Vac attachment is easily attached to the machine
and connected to the vacuum cleaner / dust collector for
effective dust management when dry cutting.
Intended use
This product is designed and intended for cutting tile and
stone. All other use is improper.
The product is intended for use in industrial applications
by experienced operators.
™
™
is an electronic overload protection that
™
™
is an electronic current limiter which provides
™
,
397 - 001 -
Publicité
Chapitres
Table des Matières
