Using Programs; Reading The Values Of A Program - Kinetec Spectra Manuel D'utilisation

Using Programs

Beginning
To stop the unit
To access the program mode
To change the program if necessary
To exit and validate the selected program
To exit without validation of selected program
Start the unit
WARNING: Always check the motion parameters displayed on the remote control before starting
the session.
Reading the values of a program: example SPEED
Beginning
To stop the unit
To access the program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing on another
key
To exit and validate the selected program
Start the unit
Comments: The current movement parameters can be changed while using that program but
no data will be stored in the original program. See the programming mode (page 9) to modify
programs.
Spectra & Spectra DC
Keys to press
40 STOP
PROGRAM
PROGRAM
30 WARM UP
Or
WARM UP
Please Wait
40 STOP
WARM UP
30 RUN
Keys to press
40 STOP
PROGRAM
PROGRAM
30 WARM UP
Or
PROGRAM
SPEED : 2
40 STOP
WARM UP
30 STOP
WARM UP
30 RUN
EN
Display
KINETEC
Check if the hand control is not
45 110 blocked (See page 5).
Nr1
The program number blinks.
EMPTY
Nr7
The new program number blinks.
90
The current parameters have been
recorded in program 7.
KINETEC
Back to the starting parameters.
45 110
The value change at the speed of
50 90 the movement.
Display
KINETEC
Check if the hand control is not
45 110 blocked (See page 5).
Nr1
The program number blinks.
EMPTY
Nr7
The new program number blinks.
90
Nr7
Displays the speed value.
KINETEC
45 110
The current parameters have been
45 90 recorded in program 7.
The value change at the speed of
50 90 the movement.
Remarks
Remarks
10/16