Electrical Connection; Starting The Unit; Changing The Display Language - Kinetec Spectra Manuel D'utilisation

Electrical connection: SAFETY FIRST.
The KINETEC Spectra and Spectra DC are type B, class I devices.
Before connecting the device to the power supply, check that the
mains voltage matches that shown on the identification plate (100-240
V~ 50-60Hz).
Connect the hand control (4)
Connect the power supply cable (25).
IMPORTANT
Check that the electrical socket is in good condition and is suitable for
the splint power supply cord. The latter complies with current standards
and has a grounding socket.
The plug may be connected to any standard socket.
The socket must however have a grounded pin.
To connect the power supply, only use the original cable supplied with
the machine.
Check that the cables remain free around the device so that they do
not get damaged.
Check that the machine is not damaged, in particular the protective
housings.

Starting the unit

Switch on the unit (9).
The display comes on, the machine carries out a self-test and the display shows in succession
Then
Movement Verify.
Then,
Nom
Prenom
Only for Kinetec Spectra DC*
Then
30 STOP
Your KINETEC Spectra or Spectra DC is ready to be used with the parameters from the previous
session, unless you are using an optimised program on the Spectra DC (see the instruction
manual for the Kinetec Data Capture software).
WARNING: Always check the motion parameters displayed on the remote control before starting
the session.
*Note: Before using the device with data recording, please refer to the instruction manual for
the Kinetec Data Capture software. The splint can be used immediately without being
connected to a computer, but the movement data will be recorded under patient 01
and may be incomplete. See page 6 on selecting the patient.

Changing the display language

Press the following buttons simultaneously:
display language.
Press the
then switch the machine off and then on again to apply the changed display language.
Available languages: English, French, German, Italian and Spanish.
Spectra & Spectra DC
KINETEC
Spectra Vxx.x
Please Wait
xx
xx
KINETEC
15 70
button to confirm,
and , followed by
EN
9
25
4
or to change the
4/16