Configuration - Giropes Baxtran STX Série Manuel D'utilisation

7. CONFIGURATION

•
Switch on the hook and, during initialisation, press and hold down the
•
D
Press the button on the remote control again and the display will show "
•
A
Press the button on the remote control to display the current step, ex. "
•
Use the D button on the remote control to change the division value and press the
the next parameter.
•
The display now shows the factory-programmed capacity. Use the
•
A
Press the button on the remote control to confirm. The display will show the value of the weighing filter, ex. "
ton on the remote control to change the filter value (the higher the value, the more stable the weight reading, but the slower the response)
•
A
Press the button on the remote control to confirm. The display will show ex. "
change the value of the zero range. (The higher the value, the smaller the deviation from zero and the greater the zero recovery. On the
other hand, high values can interfere with the weighing of light loads)
•
A
Press the button on the remote control to confirm; the display will show "
off time.
0 = no automatic power off
1 = auto power off in 15 minutes
2 = auto power off in 30 minutes
•
A
Press the button on the remote control to confirm and return to normal weighing mode.
D
button on the remote control to display "
SET
".
d 2 → e=2kg
".
A
button on the remote control to confirm and access
D
button on the remote control to change the value
rng 1
". Use the
AUPf0 D
". Use the
USER'S MANUAL STX
CAL SP
".
fLT 00
". Use the
D
button on the remote control to
button to select the desired auto power
EN
D
but-
13