Elem Garden Technic TDTPL41HP35P Manuel D'utilisation page 36

8-MAINTENANCE
WARING: stop the engine and unplug the spark plug before any repairing or maintenance
operations.
:Stop the engine and unplug the spark plug before any repairing or maintenance operations.
- For four strokes engine read carefully the maintenance engine manual. Check regularly the
oil level and add some oil or replace it if necessary.
- Frequently check the lawnmower and ensure that all grass deposits are removed from
beneath the deck.
- Lubricate regularly the wheel axle and the bearings with grease.
- Check often the blade, in order to obtain a clean work the blade should always be sharp and
well balance.
- At regularly intervals check the tightening of all bolts and screws. Wear off or badly tightening
nuts and bolts can involve some important damages to the engine or the frame.
- If the blade hits violently an obstacle, stop the lawnmower and bring it to agreed service
station.
THE BLADE: the blade is made of pressed steel, in order to obtain a clean work sharpen the blade
frequently, around every 25hours of work. Be sure that the blade is always well balance, introduce a
small iron axle(φ2 or φ3 mm) in the central hole of the blade, it should stay horizontal.
If the blade does not stay horizontal balance it by taking off some metal on the side, which is down.
YOU MUST ONLY USE THE MANUFACTURER BALDE IT SHOULD BE REFERENCED AND
WEAR THE MANUFACTURER BRAND "Gians"
To remove the blade, unscrew the screw, ○1check the blade support and change all spare parts if they
are worn out or damage.
When reassembling the blade, make sure that the cutting edges face in the direction of the engine
rotation. The blade screw must be torque to 3.7 K·gm (37Nm) with a Dynamometric tool.
ONLY USE ORIGINAL SPARE PARTS. SPARE PART OF BAD QUALITY CAN INVOLVE
IMPORTANT DAMAGES TO YOUR LAWNMOWER AND BEPREJUDICIAL FOR YOUR SECURITY