Remote Control; Maintenance And Storage - Ayce TF1005LR-E Mode D'emploi

REMOTE CONTROL

1. Install one CR2025 lithium button battery (not include).
2. The Remote Control power button is labeled as such.
All the functions performed with the Remote Control
work identically to the Manual Controls.
OPERATION
The FAN may be operated by the manual controls located on the FAN (as shown in
Figure 3) or by your remote control (shown in Figure 2).
1. Place the FAN on a stable flat surface. Plug the cord set into a 230V~A.C.
electrical outlet.
2. POWER: Turn the FAN on by pressing the "Marche/Arrêt" button; Turn the FAN
off by pressing the "Marche/Arrêt" button again.
3. SPEED: You can adjust the fan speed to the desired level: low, medium, or high
by pressing "Vitesse" . The speed setting is displayed on the FND screen(shown
in Figure 4) .
4. MODE: Pressing the "Mode" button will set the FAN into NORMAL, NATURAL,
and SLEEP mode .
The set mode is displayed in the "STYLE" on the display.
4.1 NORMAL Setting at any speed, the fan runs at this level until it is
set again.
4.2 NATURAL The air circulation changes cyclically from low,medium
to high.
4.3 SLEEP
If set the night mode at low speed, the unit runs continuously at low speed.
If set the night mode at medium speed, the unit runs at medium speed for 30
minutes and then pends at low speed.
If set the night mode at high speed, the unit will run at high speed for 30 minutes,
then for 30 minutes at medium speed and then turn to low speed.
5. TIMER: The fan is equipped with a timer that allows you to set it's length of
operation from 1 hour to 12 hours. Once the unit plug into the power socket or
switch on, the FND will show the room temperature, and the
'TEMP' will change to 'TIMER' when the timer is set.
6. OSC: Pressing the 'OSC' button will start and stop the oscillation function.
The symbol is displayed on the FND screen.
7. Power save mode: when the 'sleep' mode or the 'timer' is on, the main display
will be off after 30 seconds, and you can press any keys to turn on the display
again.
(Figure 2)
(Figure 3)

MAINTENANCE AND STORAGE

Turn off the fan and unplug it before cleaning.
DO NOT immerse the fan in water or its cable in water or any other liquid, and do not
allow any liquid to enter the fan.
Do not use detergent , gasoline, or any other chemical on the fan.
For storage, clean the fan carefully as instructed and store it in the original package in a
cool dry place
42 | 43 D G
(Figure 4)