Pioneer PDK-TS01 Mode D'emploi page 14

Instructions for using the main display packing material as a stand for
the working on the display (50" display model is shown in the figure.)
• Main plasma display packaging setup
Step 1. Construct the stand for the plasma display using the inner box frame and pads shown in
the figure above (all pads are identical).
Inner box frame
Step 2. Set the plasma display down on the pads as shown in the figure below.
Step 3. Follow the instructions in Steps 1-4 in "Normal Installation" to attach the stand to the
plasma display.
14
Outer box
Pad
Pads
Mirror mat
Inner box frame
Plasma display
Plasma display
Pad
Mirror mat
Inner box frame topped by two pads