Installation; Installation Of The Unit; Connection; Moving And Transport - Enraf Nonius Radarmed 950+ Manuel D'utilisation

8 Installation

8.1

Installation of the unit

• Do not install the unit in a location near to a heat source such as a radiator.
• Avoid exposure to direct sunlight, rain, excessive dust, dampness, mechanical vibrations and
shocks.
• Electronic equipment such as cordless telephones should not be used in close proximity of the
unit.
• This unit may not be used in so-called "wet-rooms" (hydrotherapy rooms).
• The unit has to be installed in such way that liquid cannot enter.
• Always use the by Enraf-Nonius for this unit prescribed original accessories.
• Do not cover the ventilation slots.
Should any liquid ingress into the housing of this equipment, unplug the unit from the wall socket (if
connected) and have it checked by an authorised expert.
8.2

Connection

• Mains supply connections must comply with the national requirements regarding medical
rooms.
• Prior to connection of this apparatus to the mains supply, check that the voltage and frequency
stated on the type plate correspond with the available mains supply.
• For safety reasons the brakes on the wheels of the unit should be locked before the beginning
of a treatment.
8.3

Moving and transport

When moving or transporting of the Radarmed 950+, never pull at the radiator or radiator arm, to
avoid the risk of tilting of the unit.
8.4

Electromagnetic interference

• Operation in close proximity (i.e. less than 2 metres) to working shortwave units may produce
instability in the Radarmed output.
• In order to avoid interference, shortwave units should not be allowed to radiate in the direction
of the microwave units, either in the same or in adjacent rooms.
• To prevent electromagnetic interference, we strongly advise using separate mains groups
(phases) for the Radarmed and the shortwave equipment. Ensure that the mains cable of the
shortwave unit does not come near the Radarmed or the patient.
• Electroacoustic equipment (e.g. radios, intercom systems, telephones systems, etc.) should be
screened against microwave irradiation if interference is experienced. It may be sufficient to
change the radiators direction of radiation.
If problems with electromagnetic interference persist, please contact your authorised supplier.
8.5

Connection mains cable

• Connect the supplied mains cable to the connection mains cable [13].
• Connect the mains cable to a grounded safety socket
8.6

Connection radiator arm

8.7

Readjustment radiator arm

See drawings for the readjustment of the radiator arm. The supplied wrenches should be used for
readjustment. We advise mounting the heaviest radiator you have when readjusting the radiator arms.
The three fixing bolts should be equally tightened.
EN109-1435752-42
ENGLISH
Page 11 of 29