Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Chapter 3
Clear paper jams
In case of a paper jam, check the rear door. You might need to clear the paper jam from the rear door.
To clear a paper jam from the rear door
1. Remove the door by pulling it away from the product.
2. Gently pull the paper out of the rollers.
CAUTION: If the paper tears when you are removing it from the rollers, check the rollers and wheels for
torn pieces of paper that might be remaining inside the product. If you do not remove all the pieces of paper
from the product, more paper jams are likely to occur.
3. Replace the rear door. Gently push the door forward until it snaps into place.
4. Press OK on the control panel to continue the current job.
Print troubleshooting
Use this section to solve these printing problems.
The product is not responding
Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the
first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.
•
Solution 1: Turn on the product
•
Solution 2: Load paper in the input tray
•
Solution 3: Select the correct printer
•
Solution 4: Check the printer driver status
•
Solution 5: Wait until the product completes the current operation
•
Solution 6: Remove all cancelled print jobs from the queue
•
Solution 7: Clear the paper jam
•
Solution 8: Make sure the print carriage can move freely
•
Solution 9: Check the connection from the product to your computer
•
Solution 10: Reset the product
Solution 1: Turn on the product
Solution: Look at the On light located on the product. If it is not lit, the product is turned off. Make sure the
power cord is firmly connected to the product and plugged into a power outlet. Press the On button to turn on
the product.
Cause: The product was turned off.
If this did not solve the issue, try the next solution.
22
Troubleshooting and support
Publicité
Chapitres
Table des Matières
Dépannage
