Making Projector Network Settings; Basic Wireless Lan (Access Point Mode) Or Wired Lan Settings - Epson EasyMP EMP-745 Guide De Mise En Route

Connecting in Access Point Mode or Wired LAN Mode
Tip :
The optimum performance can be obtained if the resolution of the computer being used
is XGA or lower and the colour settings are for 16-bit colour (Windows) or Thousands
(Macintosh).
Caution :
• Do not remove the wireless LAN card while the access lamp of the wireless LAN card is
flashing green, otherwise it may damage the wireless LAN card.
• For information about the wired LAN card access lamp(s), refer to the documentation
of the wired LAN card you are using.

Making Projector Network Settings

This describes the basic settings that are required in order to use a wireless LAN
(access point mode) or a wired LAN.
The connection settings described here can be made using the remote control that is
included with the projector.
Tip :
• This setting only needs to be made once, and will be kept from then on.
• The setting methods described here are carried out using the remote control, but once
you have connected in easy connect mode, you can also use the computer's web
browser to make the settings. This method allows you to use the computer's keyboard to
make the settings more easily.
"Changing Settings Using a Web Browser (EasyWeb)" in the EasyMP Operation
Guide
• Apply the following settings under the direction of the network systems administrator.

Basic Wireless LAN (Access Point Mode) or Wired LAN Settings

Procedure
1
Insert the LAN card into the card slot of the projector.
2
Press the [Power] button to turn the projector on.
3
Press the [EasyMP] button.
EasyMP standby screen will be displayed.
34
p.19