Kroeplin B Série Mode D'emploi page 19

Function
Selection of the measuring programs
MIN
MAX
HOLD
TOL
MIN + TOL
MAX + TOL
HOLD + TOL
Switch over to continous
display
SETUP – Menu
Start SETUP
OFFSET
TOL
UNIT
RES
Quitting SETUP
Note: The gauge switchs back into the last used measuring mode, if no key has been pushed for longer than 30 sec. in the setup
menu. Changings in the setup menu will be adopted.
Basic Action
1x
2x
3x
4x
5x
6x
7x
8x
1x
2x
3x
4x
1x
19
Result
This function can be used for ABS
measurement as well as REL
measurement.
Note:
Measuring programs MIN and MAX
are active until changing them into
the next measuring mode, without
pressing any key.
After selection of the measuring
program HOLD, this is active, as
soon as the movable measuring arm
leaves one of the two limit stops. To
renew starting of the measuring pro-
gram the movable measuring arm
must be led again at one of the limit
stops (the stored measured value will
be deleted)
The LED expires 5 sec. after having
found a measuring value.
It switches on after having found a
new one.
SETUP Menu can be started within
every measuring mode
0 point adjustment
(see specification page 20)
Adjustment of the tolerance limits
(see specification page 20)
Select MM / INCH
(see specification page 21 / 22)
Adjustment of the scale interval
(see specification page 22)
Last mode with corrected adjust-
ment will be shown
Remarks