Kroeplin B Série Mode D'emploi page 17

No. Display Function
4 HOLD Finding and saving of
the measured value
5 TOL Activation of the toler-
ance marks and the tol-
erance display
(red and green LED)
Setup – Menu is active
6 SET
7 MM Representation of the
measured value in MM
8 INCH Representation of the
measured value in INCH
14 Red LED Measured value is out of
tolerance
15 Green Measured value is with-
LED in tolerance
Remarks:
= press the key shortly
= press the key long (> 2 sec.)
Application
If the gauge cannot be used vertical and horizontal.
Hold gauge steady around 2 sec.
Measurement :
Example: B440T
During series measurements the observance of the given tolerances will
be checked.
Example: Diameter 10 +/-0,1mm will be checked
Measurement / Display:
Measuring value within tolerance
The LED expires 5 sec. after having found a measuring value.
It switchs on after having found a new one.
Possible Settings:
- Configuration of the zero setting adjustment
- Upper and lower tolerance limit
- Measuring unit mm / INCH
- Numerical interval / Scale interval
For fast identification of reject parts.
For fast identification of good parts.
17
Measuring value out of tolerance
(OFFSET)
(TOL)
(UNIT)
(RES)