Gas Hose & Regulator; Gas Requirements - Italkero ETNA Manuel D'utilisation

Regulators and hose must comply with EN16129, EN16436-1 and EN16436-2 , in additional to applicable national
regulations.
It's extremely important that you DO NOT route the gas hose under the directly under burner. Do not allow the
hose to touch any part of the burner or heater. The hose should be located so that it is not subjected to undue
strain or placed where is could be damaged.
 Use propane or butane gas only.

Always use the correct pressure regulator and hose assembly suitable for the gas cylinder. Contact your local
gas supplier for further advice if needed.
 Dented, rusted or damaged gas cylinders may be hazardous and should be checked by your gas supplier.

Never use a cylinder with a damaged valve connection.
 Never connect an unregulated gas cylinder to the heater.
Maximum Gas Bottle Size
Notice-Gas bottle Chain
When the gas bottle placed in cabinet, you must be hing on the door chain as below picture.
Gas hose & Regulator
WARNING!!!

GAS REQUIREMENTS

13