Troubleshooting Support; Technical Data; Identification Plate - DURAVIT Jet-System Notice D'utilisation

7. Troubleshooting support

CAUTION!
The whirlpool tub may be repaired only by qualified plumbers and electricians.
Problem
Foaming
The whirlpool system runs
only briefly?
Whirl system does not start? Mains switch switched off.
Buttons do not function
properly?
Sound of motor during filling
/ after draining the tub (2nd
floor)
Sound volume / quality can-
not be changed.

8. Technical Data

8.1 Identification Plate

The identification plate is on the back page of the Operators Manual.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764
Potential cause
Soap or shampoo in the
bathwater.
Water level too low.
Mains fuse is switched off.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
Air in button after whirl sys-
tem has been standing idle.
Residual water drain lines are
being opened / closed.
Data not compatible.
Solution
>
Switch off the
whirlpool system.
>
Fill the tub with
fresh water.
>
Add water until the water
level is about 5 cm above
the uppermost nozzle.
>
Press "Jet" for a while.
>
Switch on at mains.
>
Switch on mains circuit
breaker.
>
Disconnect tub from
mains.
>
Call Customer Service.
>
Press button once again.
>
Check whether the audio
source supports the A2DP
protocol.
25