Cleaninh And Service - Fisher Scientific Power Overhead Stirrer Manuel D'instructions

Other button functionality
• If the stirrer is powered off when in zero torque mode (N-cm LED fl ashing), the
stirrer will be in this mode when powered back on. If the stirrer is unplugged or
power is interrupted, the stirrer is reset and the feature will not be active.
• The speed can be changed any time – while the stirrer is running or in pause.
When the speed is changed, the speed in rpm is displayed while the speed is
adjusted. If torque was displayed prior to the change in speed, the display will
change back to displaying torque once the new speed is set.
• The zero torque feature can only be activated when the stirrer is running.
• When the zero torque button is pressed while the stirrer is running and rpm is
displayed, actual torque will be displayed. Press the zero torque button again,
the N-cm LED fl ashes indicating the stirrer is in zero torque mode.
Cleaning and Service
Cleaning
Using a mild soap and water solution, wipe the housing and control panel of the
stirrer with a damp cloth. Do not use chlorine bleach, chlorine-based cleanser,
abrasives, ammonia, steel wool, or scouring pads with metal content or similar
harsh solvents or abrasives. These may damage the surface of the stirrer.
Service
Do not attempt to service or repair a Fisher Scientifi c stirrer. If the stirrer
housing is opened, the warranty becomes void. Contact Fisher Scientifi c for
return authorization and return instructions.
Clean the stirrer so that it is free from any materials which may be harmful.
Provide an MSDS or other safety data sheets for all chemicals used in
conjunction with this stirrer where appropriate. Place the stirrer and its parts
into the original packaging to protect and prevent damage during transport.
Follow shipping directions provided by Fisher Scientifi c when return is
authorized and RMA issued.
CAUTION: Failure to clean, service, and handle the stirrer as outlined
above can cause it to fail which could impair the safety of the user.
15
15