Technical Specifications - ResMed Power Station II Mode D'emploi

Masquer les pouces Voir aussi pour Power Station II:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Technical specifications

Battery technology
Capacity
UN classification
AC power supply
DC converter
Battery output voltage
Power supply unit output
current (rated)
Battery output current (rated)
Standby current
Protection
Dimensions (L x W x H)
Battery weight
System weight
Minimum life cycle
Operating conditions
Charging
Discharging
Transport/storage conditions
Operating/storage air pressure
Aircraft use
Recharge time
Electromagnetic compatibility
IEC 60601-1 classification
Battery run time
Using 15 cm H
O (IPAP), 5 cm H
1
2
when using heated humidification and heated tubing.
6
Lithium ion
< 100 Wh (97 Wh)
UN3480 (lithium-ion batteries)
Input range 100–240V, 50–60Hz, 1.0-1.5A
Nominal for aircraft use 110V, 400Hz
Input range 12V / 24V, 13A / 6.5A
(24V / 26V) ± 0.5V, 90W continuous
3.75 A
3.75 A / 3.46 A
< 100 μA
Overcharge, overdischarge, excess current, short circuit,
high temperature
9.1" x 5.0" x 1.0" (230 mm x 126 mm x 26 mm)
2.0 lb (0.9 kg)
5.1 lb (2.3 kg)
≥ 500 cycles at 73°F (23°C) to 60% capacity
41°F to +104°F (5°C to 40°C); 5–85% maximum humidity
23°F to +104°F (-5°C to 40°C); 5–85% maximum humidity
-4°F to +113°F (-20°C to +45°C); 5–85% maximum
humidity
600 hPa to 1100 hPa
Product meets the Federal Aviation Administration (FAA)
requirements (RTCA/D0-160, section 21, category M) for
all phases of air travel.
< 4 hrs at full level
Product complies with all applicable electromagnetic
compatibility requirements (EMC) according to IEC60601-
1-2, for residential, commercial, and light industry
environments. Information regarding the electromagnetic
emissions and immunity of these ResMed devices can
be found on www.resmed.com/downloads/devices.
Class II (double insulation) and/or Internally Powered
Equipment, IP21 (IP20 while charging), Continuous
Operation (from mains), Limited Operation (from
battery), Equipment not suitable for use in the presence
of a flammable anaesthetic mixture with air or with
oxygen or nitrous oxide.
> 8 hrs at average device settings
For more information, see the Battery/Device
Compatibility List on www.resmed.com/downloads/devices.
O (EPAP), and 15 BPM (Respiratory Rate). Not applicable to devices
2
1

Publicité

Table des Matières
loading

Table des Matières