ResMed Power Station II Mode D'emploi page 11

• Ensure the internal battery of any connected device is kept charged up to
provide backup power in the event of loss of power from RPS II.
• Only use a supplied ResMed 90W AC power supply unit or DC converter for
charging the RPS II.
• Explosion hazard—do not use in the vicinity of flammable anesthetics.
• The RPS II system is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the RPS II system by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the RPS II
system.
•
Care should be taken to keep the power supply unit adapter dry. The RPS II
system, while connected to a device and discharging, is rated to IP21 (Drip
proof) according to IEC60529. When charging, the RPS II system is rated to
IP20 (No protection) due to the power supply unit adapter which is rated to
IP20. The AC power supply, RPS II battery and DC converter are rated to IP21.
•
Only use ResMed power supplies that are compatible with the RPS II for
charging. For a list of compatible power supplies for RPS II, see the Power
Supply Unit/Device Compatibility List on www.resmed.com.
CAUTIONS
• Avoid hard, physical impact on the battery.
• Before using for the first time, ensure that the RPS II and its components are
in good condition and operational. If there are any defects, the system should
not be used.
• The RPS II is to be used only in accordance with the intended use stated in
this guide. Damage to equipment or injury can result from modifications to
the equipment or operation.
•
Always fully charge the RPS II before use, or before relying as a backup
power.
• Monitor the charge level of the RPS II. When the charge level is low, ensure
that continuity of power can be maintained.
• When in use, always plug the cable from the RPS II into the device. Keep the
RPS II power switch turned on to ensure it can provide backup power.
• When transporting, turn off the RPS II, unplug all cables, and pack in the carry
bag.
• Medical electrical equipment requires special precautions regarding EMC and
needs to be installed and operated according to the information provided in
this user guide. Portable and mobile communications equipment can affect
medical electrical equipment. If EMC interference is observed, for example
static on radios, move the RPS II away from other equipment.
Notes:
• The above are general warnings and cautions. Specific warnings, cautions, and
notes appear with the relevant instructions in the guide.
• For any serious incidents that occur in relation to this product, these should be
reported to ResMed and the competent authority in your country.
8