Wall-Mounting Your Tv; Specifications - Insignia NS-LCD19-09CA Guide De L'utilisateur

Insignia NS-LCD19-09CA 19" LCDTV 720P
Symptom Possible solution
"Ghost" or double image
Remote control does not
work
Snowy picture or noise
VGA picture is not stable
or synchronized
No output from one of
the speakers
Control buttons do not
work
After images appear

Wall-mounting your TV

Wall-mount hardware (sold separately) lets you
mount your TV on a wall. For detailed
information on mounting your TV on a wall, see
the instructions provided with the wall-mount
hardware.
Contact a technician for assistance when
installing the wall-mount bracket. Best Buy is not
responsible for any damage to your TV or injury
to yourself or others.
We suggest that you keep your TV at least
2.36 inches (60 mm) from the wall to prevent
cable interference.
• This may be caused by
obstructions to the antenna,
such as high-rise buildings or
hills. Using a highly directional
antenna may improve the
picture quality.
• Press TV.
• Replace the batteries. Make
sure that the + and – symbols
on the batteries align with the +
and – symbols in the battery
compartment.
• Clean the remote sensor on the
front of your TV.
• Bright or fluorescent lighting
may interfere with the remote
control signal. Turn off the light
or move your TV.
• Make sure that the A/V and
antenna cables are connected
correctly and securely.
• Make sure that you have
selected the correct VGA mode
on your computer.
• Adjust the balance in the Sound
menu.
• Unplug the power cord, wait a
few seconds, then plug the cord
back in and turn on your TV.
• Do not display a still image,
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent after
image to be burned into the
screen. This type of damage is
not covered by your warranty.
www.insignia-products.com
To attach a wall-mount bracket to your TV:
1 Remove the three M4 screws holding your
TV to the stand.
100 mm
Attach wall
bracket here
M4 screws
2 Remove the screw from the bottom of the
base.
Screw
3 Secure the wall-mount bracket to the back of
your TV using four M4 screw, as indicated in
the illustration in Step 1.

Specifications

Design and specifications are subject to change
without notice.
System NTSC
Screen 19-inch
Channel coverage Air: 2 ~ 69
Cable: 2 ~ 125
Power source AC 100 V~240 V 50/60 Hz
Power consumption <80 W
<1 W in standby mode
Audio power 2 W + 2 W internal speaker
S-Video input Y: 1 V(p-p), 75 ohm, negative sync
C: 0.286 V(p-p) (burst signal), 75 ohm
Video/audio input Video: 1 V(p-p), 75 ohm, negative sync
Audio: 150 mV(rms)
M4 screws
13