Maintenance; Maintenance Schedule - Jonsered LM2146C Li58-52 Manuel D'utilisation

LED lights Battery status
LED 1, 2 and 3 The battery pack is 75% - 51% charg-
come on ed.
LED 1 and 2 The battery pack is 50% - 26% charg-
come on ed.
LED 1 comes The battery pack is 25% - 6% charg-
on ed.
LED 1 flashes The battery pack is 5% - 0% charged.
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
General recommendations for

maintenance

The warranty on this product does not include incorrect
or not careful operation of the product by the operator.
To receive full value from the warranty, the operator
must do maintenance on the product as written in the
instructions of this manual. Different adjustments must
be made at different intervals to keep your product in
correct work condition.
• Examine the blade for wear each year.
To examine the tires
• Keep the tires free of unwanted material and
chemicals to prevent damage to the rubber.
• Keep the tires away from stumps, stones, ruts, sharp
objects and other objects which can cause damage
to the tires.
To do a general inspection
• Check that nuts and screws are tight.
• Make sure no cables are pinched.

Maintenance schedule

Use the maintenance schedule to see the necessary
maintenance requirements of your product, and when
the maintenance must occur. The intervals are
calculated on average use of the product and may be
different because of how frequently you use it.
• Tighten bolts and nuts before each use and before
storage.
• Clean and examine the grass catcher, if installed,
before and after each use, and before storage.
• Examine the tires before each use.
• Clean the product after each use and before storage.
Use a scraper to clean below the deck.
• Examine the blade for damage and cracks in 25 hour
intervals. Replace blades more frequently if you cut
in sandy soil.
• Lubricate the product in 25 hour intervals.
12
If there is an error with the battery pack during
operation, all four green LEDs of the battery state of
charge display flash. Remove the battery pack from the
machine and press the indicator button on the battery
pack to show the error code for the error. The LED's on
the battery pack illuminate and show an error code if an
error has occurred. Consult the battery manual for a list
of error codes and solutions to the errors.
MAINTENANCE
• Clean and fully charge the battery pack after use and
after storage. Charge the battery pack for max. 24
hours before storage.
• Do not keep the battery pack on the battery charger
during storage. Charge the battery pack for a
maximum of 24 hours.
• Examine the drive belt and pulleys in 25 hour
intervals (if equipped).
To clean the product
• Use a brush to remove unwanted material and grass
on the product.
• Keep unwanted material off finished surfaces and
wheels.
• Use a scraper below the product to remove the
buildup of grass and waste.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the electrical
powerhead or battery contacts.
• When you clean below the product, remove the
battery pack and the safety key and put the product
on its side with the user control interface pointing up.
To clean the grass catcher
• Pores in cloth grass catchers can become filled with
dirt and dust during operation. This causes the grass
catcher to collect less grass. To prevent this,
regularly hose the grass catcher off with water and
let dry before using.
• Examine the grass catcher frequently for wear or
deterioration. Replace if necessary.
To examine the rear door
The rear door is attached between the rear wheels of
the product. The door decreases the risk of objects that
may be ejected in the direction of the mow position of
the operator.
1. Make sure that the rear door is not damaged.
CAUTION: Do not clean the product with
water, cleaning fluids or solvents. Remove
unwanted material external to the product
with a soft brush or dry cloth that does not
contain metal.
851 - 003 - 23.10.2018