Assembly; Operation - Jonsered LM2146C Li58-52 Manuel D'utilisation

WARNING: Read the safety chapter before
you assemble the product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Cut down the two end corners of the carton and put
the end panel down flat.
3. Remove all package materials.
4. Remove the product from the carton and make sure
no loose parts are left in the carton.
To assemble the handle
1. Align the screw holes at the bottom of the handle
with the screw holes in the handle assembly. Attach
the screws, washers and knobs. (Fig. 29 )
2. To set the handle height, loosen the lower knobs, lift
or lower the handle to adjust the height, and then
tighten the knobs fully.
To set the product in operation
position
1. Lift the handle to the operation position.
2. Tighten the lower knobs fully.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig.
30 )
2. Attach the bottom section of the grass catcher frame
to the groove on the bottom of the grass catcher.
(Fig. 31 )
3. Attach the hooks on the grass catcher to the top
edge of the chassis. (Fig. 32 )
4. Put the lower part of the grass catcher into the grass
discharge channel.
To change the product to bagging
mode
Rear bagging mode collects grass clippings in the grass
catcher.
WARNING: Read and understand the safety
chapter before you operate the product.
10

ASSEMBLY

1. Lift the rear door and put the grass catcher frame
hooks on the rear door pivot. (Fig. 33 )
2. Release the rear door and put it on top of the grass
bag frame.
To change the product to mulching
mode (if equipped)
The mulching mode of the product makes grass
clippings smaller. The grass clippings then fall onto the
lawn and across the grass. Mulched grass biodegrades
quickly to give nutrients for the lawn.
1. Lift the rear cover and remove the grass catcher.
(Fig. 34 )
2. Put the mulch plug into the discharge channel. (Fig.
35 )
3. Tightly close the rear door against the product.
To change the product to discharge
mode
1. Remove the mulch plug or grass catcher. (Fig. 36 )
2. Tightly close the rear door against the product.
To set the cutting height
Note: Set the same height on all cutting height controls.
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 37 )

OPERATION

CAUTION: Do not operate the product
without the rear door closed or the approved
grass catcher in position. Do not try to
operate the product with the rear door
removed or open.
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
851 - 003 - 23.10.2018