Walter Surface Technologies BIO-CIRCLE COMPACT-S 350 Manuel De L'utilisateur page 10

Operating Instructions
3. Turn the cleaning pump ON & OFF by pressing the ON/OFF button (E).
To minimize fluid consumption, always turn the cleaning pump OFF
after use by pressing the pump switch (E) again.
Rinse the sink and any brushes prior to cleaning; this will prevent
grease and dirt from sticking to the surfaces.
The bio-CirCle
through brush (C), which is well suited for most cleaning applications.
However, for best results, when cleaning smaller or intricate parts, it is
recommended to run the cleaning solution through the flexible faucet
(A) and use brushes that are adapted to the shape of the part being
cleaned.
Always clean parts while holding them under the flow of liquid.
4. For optimum performance, always keep the unit topped-up to the
proper working level of at least 100 liters/26.5 gal. do not fill above the
MAX level. Do not allow solution level to fall below 90 liters/23.7 gal.
Observe fluid level lines molded into the tank wall.
When the solution level falls below the minimum, the float switch will
cut the power to the cleaning pump and heater coil. The air pump,
however, will continue running.
Check the fluid level every other week and top-up as necessary to
operating level.
10
Compact-S Model 350 - Parts Cleaning System
®
unit is supplied with an efficient multi-jet flow-
(...continued)
MAX. 120 L / 31.7 gal.
MIN. 90 L / 23.7 gal.