b. Camera
Lens: ¼ CMOS
Resolution: 360 TV lines
Viewing angle: H 37° / V 27°
Sweep angle:
Battery autonomy: 2 hours
Power supply: 5V
Size (L x D x H): 98 x 89 x 85 (mm)
c. Monitor
Screen: 3.5'' TFT-LCD
Resolution: 320 x 240
Battery autonomy: 2 hours
Power supply: 5V
Size (L x D x H): 125 x 90 x 23 (mm)
7. MAINTENANCE
The guarantee is void if parts have been dismantled. Clean the outside with a soft, dry cloth only. Before
cleaning, disconnect or switch off the video surveillance system.
Warning
Do not use any carboxylic acid, alcohol-based or other similar product or solvent. In addition to the risk of damage to
your device, fumes are also dangerous to health and are explosive. Do not use any tool which may conduct electricity
(metal brush, pointed tool or other) to clean the equipment
8. TROUBLESHOOTING
You have purchased a ready-to-use video surveillance system using the latest technology. All the parts re-
quired to get full use of your kit are provided.
However, if you encounter problems or malfunctions, you can remedy them by reading the table below:
Fault
The monitor does not turn on.
No image.
No sound
If required, our technical site is at your disposal: www.cfi -extel.com
The latest version of the instructions in colour is downloadable from:
WARRANTY TERMS
This appliance has a parts and labour warranty in our workshops.
The warranty does not cover: consumables (batteries, etc.) and damage caused by: incorrect use, incorrect
installation, third party intervention, deterioration through physical impact or electric shock, dropping, or
atmospheric phenomena.
• Do not open the appliance as this will void the warranty.
• When returning the appliance for eventual servicing, protect the screen to avoid scratches.
Cause
• Power supply problem
• No more battery
• The camera is not powered on
• The monitor is not receiving the
signal
• The camera is not paired
• Settings
CFI EXTEL O'CONTROL - 10/2015 - V1
Solution
• Check the adapter is connected
• Connect the monitor to the
mains power supply
• Check the adapter is connected
• Move the camera closer and fi nd a
more suitable position
• Carry out pairing
• Check that the volume is not set
to the lowest position
www.cfi -extel.com
GB5