Geberit HyTronic Mode D'emploi page 36

Service
Parameters
Menu item Description
[EN]
[DE]
40 Set flush time.
[FlshTime] Duration of the flush after one
[Spülzeit] use
41 Set detection time.
[DetectT] Minimum time within the
[VerweilZ] detection range to be
recognised as a user
42 Set delay of follow-up flush.
[DelFollwF] Is active when menu 36 "Select
[FolgVerzö] follow-up flush" is [ON] [E N]
43 Set flush time - interval flush.
[IntFlushT] Is active when the menu 32
[IntervSpZ] "Select interval flush" is
[ON] [E N]
44 Set flush interval - interval flush.
[IntervalT] Is active when the menu 32
[IntervalZ] "Select interval flush" is
[ON] [E N]
45 Set cleaning time.
[CleanTime] Defines the length of inactive
[ReiniZeit] time of the flush control when
the menu 25 [CleanMode]
[Reinigung] is started
Counters
Menu item Description
[EN]
[DE]
50 Total number of days of operation.
[Days?] Displays the number of days of operation since commissioning
[SumBetrT?]
51 Total number of uses.
[Uses?] Displays the number of uses since commissioning
[SumBenut?]
52 Total number of flushes.
[Flushes?] Displays the number of flushes since commissioning
[SumSpül?]
53 Number of days of operation power-on.
[ Days] Displays the number of days of operation since the unit was last switched on
[ SumBetrT]
54 Number of uses power-on.
[ Uses] Displays the number of uses since the unit was last switched on
[SumBenut]
55 Number of flushes power-on.
[ Flushes] Displays the number of flushes since the unit was last switched on
[SumSpül]
36
Application
a) Optimisation of flushing the
urinal ceramic
Note water consumption
Preventing flushes due to
unintentional entry into the
detection range
-
-
-
-
Adjustment Factory
range setting
3 - 15 s [...] 4 s [4]
3 - 15 s [...] 7 s [7]
1 - 24 h [...] 2 h [2]
3 - 180 s [...] 5 s [5]
1 - 168 h [...] 24 h [24]
1 - 16 min [...] 10 min [10]
Output
[...] days of operation
[...] uses
[...] flushes
[...] days of operation
[...] uses
[...] flushes