Bosch UHI Série Manuel D'utilisation page 66

66 en | Installation
2.
CAUTION!
Be sure to securely tighten all fittings to ensure a liquid-tight
seal. Failure to do this could allow water to enter the housing
and damage electronic parts, camera, and lens.
3.
4.
F.01U.167.418 | 3.0 | 2010.04
Pull any excess wire out of the housing and tighten the
fitting to 8.5 Nm to 9.0 Nm (75 inch-lb to 80 inch-lb). This
torque rating is approximately one to one and a half turns
past the point where the fitting starts to grip the wire.
Connect the supply power wires to the terminal block. See
Figure 5.8. Strip no less than 6 mm (0.25 in) and no more
than8 mm (0.31 in) of insulation away from the wire. Be
sure not to nick the wires.
Cut the power cord on 120 VAC and 230 VAC camera
models; leave enough cable to allow connection to the
terminal block. Strip no less than 6 mm (0.25 in) and no
more than 8 mm (0.31 in) of insulation away from the wire.
Be sure not to nick the wires. Connect these wires to the
connectors provided on the terminal block. See Figure 5.8.
Installation Manual
UHI/UHO Series
Bosch Security Systems, Inc.