Use; Drainage - Vortice DEUMIDO 20 EVO Notice D'emploi Et D'entretien

ENGLISH

Use

Fig.2
1) MOISTURE SETTING button
2) Operating mode indicator light (CNT continuous mode, moisture 40%, 50%, 60%, 70%)
3) Moisture/temperature display
4) Timer function indicator light
5) Temperature display button
6) CLEAN AIR indicator light
7) LAUNDRY DRYER indicator light
8) LAUNDRY DRYER button
9) High ventilation indicator light
10) SPEED/VENTILATION button
11) Low ventilation indicator light
12) ON indicator light
13) ON/OFF (ignition) button
14) "Full tank" indicator light
15) TIMER button
16) CLEAN AIR button
• Connect the device to a suitable fixed outlet. (See the label on the back of the unit for the correct voltage and
frequency)
• ON / OFF button: press to turn the device on/off. The compressor will start/stop.
• MOISTURE SETTING button: press to set the desired operating mode: continuous mode, moisture 40%, 50%, 60%
or 70%. The corresponding light will turn on. The device dehumidifies until it reaches the set relative humidity rate.
If a moisture value has been set that is higher than the room value, or if the set moisture level has been reached,
the device stops dehumidification, continuing to work in CLEAN AIR mode. The dehumidifying function will be
restored after about 3/4 minutes after continuous mode CNT has been set again or after a lower moisture value has
been set.
• SPEED/VENTILATION button: press to set the fan speed: high or low. The corresponding light will turn on.
• TIMER button: press to set the desired hours of operation (1-24 hours). When it is pressed, the display will show the
hours set. When it is released, the display will again show the moisture in the room after about 8 seconds. The
compressor will stop automatically when the set hours have elapsed. Press the TIMER button with the device
switched off for a delayed device start-up: i.e. if the timer is set to 2, the device will start operating automatically after
2 hours.
• TEMP button: press to view the room temperature on the display. When released, the display will again show the
moisture in the room after about 8 seconds.
• LAUNDRY DRYER button: press to activate high speed ventilation, able to continuously dry the moisture present in
the air, so as to dry laundry faster.
• CLEAN AIR button: press to activate the function in which the device recirculates with air filtration. The desired
ventilation speed can be selected.
• AUTO-RESTART function: in the event of temporary suspension of the power supply, the device resumes
operation while maintaining the previously programmed settings when power is restored.

Drainage

While the water tank is full, the compressor will stop for self-protection and the water full indicator will turn red.
To move the water tank, pull it out squarely from the unit. An audible alarm will sound.
After empting the water tank, place the water tank into space. Make sure it is properly positioned, in order for the
'water full' sign to go out and your dehumidifier is operating.
Please note, in case, the water tank has not been positioned well, the water full indicator will turn red.
Continuos drainage
When the dehumidifier is operated at very high humidity levels, the water tank will require more frequent drainage.
In this situation, it may be more convenient to set the unit up for continuous drainage with the following procedu-
res:
• Connect the spout for continuous drainage with water tube of inner diameter: 11 mm. The water tube is not
supplied with the unit.
• Ensure the water will always drain away freely and the tube will remain in right place.
Note! In very cold weather conditions, precautions should be taken to prevent the water tube from freeing.