Installation; Parts - Vortice DEUMIDO 20 EVO Notice D'emploi Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
ENGLISH
• Do not use the unit in potentially explosive environments that contain liquid, gaseous or dusty fuels.
• Do not pour or spray water on the device.
• Do not use other cables to extend the length of the supplied power cable.
• Avoid pulling, twisting or knotting the power cable. Do not use nylon or wire to tie the power cable.
• To prevent the formation of ice on the evaporator, never use the device in environments with temperatures
below 5°C.
• Check that cabling will not be subject to wear, corrosion, excessive pressure, vibration, sharp edges or any
other adverse environmental effects. The check shall also take into account the effects of aging or continual
vibration from sources such as compressors or fans.

Installation

Excess moisture will travel throughout your home, in the same way that cooking smells waft to every room in the
house. For this reason, the dehumidifier should be positioned, so that it can draw this moist air towards it from
all over the home.
Alternatively, if you have a serious problem in one area you can begin by positioning the dehumidifier close to
this area and later moving it to a more central point. When positioning the dehumidifier, ensure that it is
placed on a level surface and that there is a minimum of 10 cm (4") of space on either side of the unit to allow
for efficient airflow.
This dehumidifier is fitted with castors for extra mobility, if you move the unit, it should first be switched off and
the water tank emptied.
We do not recommend the use of an extension lead, so please try to ensure that the unit is sufficiently close to
a fixed mains socket. If it is necessary to use an extension lead, please ensure the diameter of the wires of the
cable are at least 1 mm
When the dehumidifier is in operation, outside doors and windows should be closed when necessary for most
efficient use.

Parts

Fig.1
a) Air outlet
b) Upper grille
c) Front panel
d) Handle
e) Rear panel
f) Moisture tank
g) Caster
h) Filter
i) Air inlet
j) Control panel
Accessoires
Active carbon filter
2
.
21

Publicité

Table des Matières
loading

Table des Matières