Spare Parts And Recommended Tools - L-Acoustics 8XTi Manuel D'utilisation

8 8 8 8 XT XT
XT XT
i COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE
user manual user manual
user manual user manual
VERSION 1.1
HF driver or diaphragm replacing procedure
1. To install a full HF driver:
a. Install the new driver on the heat dissipation plate (if necessary, add a few additional thermal paste
above the old thermal paste on the driver in a continuous circular way).
b. Screw in both Torx
c. Install the HF assembly on the LF speaker and screw in both hex screws through the plate (hex 4 mm, 5
N.m/45 in.lb , thread-locker).
f
To install a diaphragm only:
a. Ensure that the voice coil gap on the driver is free from any particles. If necessary, clean out the gap by
using 2-sided tape.
b. Install the new diaphragm in the gap.
c. Screw in the 4 Pozidriv
the torques between screws at every moment while screwing in so as to properly center the diaphragm.
2. Connect both cables to both new diaphragm electrical sockets: connect the SHORT red cable to the red-
labeled pin and the SHORT black cable to the unlabeled pin.
3. Install the loudspeaker assembly in the enclosure and screw in the 4 hex screws with split and flat washers:
into each hex screw insert a split washer and then a flat washer (following this sequence) and screw in the
assembly to one of the four locations (hex 4 mm, 3 N.m/27 in.lb
4. Install the grill (logo oriented towards vents) and screw in the 4 Torx
8.4

Spare parts and recommended tools

8XTI_UM_ML_1-1
®
screws on the rear face of the plate (T30, 5 N.m/45 in.lb
®
screws on the back cover of the driver (PZ.2, 3 N.m/27 in.lb
Table 5: Main available spare parts
HP BM12 1.5'' driver – 8 Ω
HS BM12 Diaphragm for 1.5''driver – 8 Ω
HP PH84 8'' coaxial speaker – 8 Ω
HS PH84 8'' recone kit
HR PH84 8'' recone kit including factory service
SE GRL8XTI Complete front grill (black)
SE GRL8XTIW Complete front grill (Pure White RAL 9010
Table 6: Recommended tools for service
Torque wrench (N.m or in.lb
PZ.2 Pozidriv
4 mm hex bit
T30 Torx
4 mm flat screwdriver
Medium-strength thread-locker (blue)
Thermal paste
w w w . l - a c o u s t i c s . c o m
, thread-locker).
f
).
f
®
screws (T30, 3 N.m/27 in.lb
)
f
®
bit
®
bit
). Note: Balance
f
).
f
®
)
18 en 18
18 18