Spare Parts And Recommended Tools - L-Acoustics KIVA COMPACT WST Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

HF driver or diaphragm replacing procedure

1. To install a full compression driver:

Install the new driver on the heat dissipation plate, the red labeled electrical socket facing the

plate indentations (if necessary, put additional thermal paste between the plate and the driver).

b. Screw the 2 hex screws on the rear face of the heat dissipation plate.

Put the HF assembly back into place in the enclosure, the plate indentations oriented towards

the right side of the enclosure (i.e. towards the locking mechanism side).

d. Screw the 4 hex screws: into each hex screw insert a Grower washer and then a standard washer

(following this order) and screw the assembly to one of the four locations.

To install a diaphragm only:

Ensure that the voice coil gap on the driver is free from any particles. If necessary, clean out the gap

by using 2-sided tape.

b. Install the new diaphragm in the gap, both red marks facing each other.

Screw the 4 Phillips

2. Connect both cables to both the new diaphragm electrical socket: connect the red cable to the red-labeled pin

and the black cable to the unlabeled pin.

3. Put one drop of medium strength threadlocker in each of the 6 screw-threads of the heat dissipation plate.

4. Place the connector cover above the HF driver. The graduations labeled on the cover must be oriented

towards the right side of the enclosure (i.e. towards the locking mechanism side).

5. Connect the white connector, insert the cover into the enclosure, and screw the 6 hex screws.

8.4