Connecting The Water Circuit; Preliminary Checks - Sanremo Portofino Mode D'emploi

ENGLISH ENGLISH
1 - Unpack the appliance and stand it stably and safely in the required location, making sure there is sufficient room for its correct use.
2 - Position the appliance on a surface high enough to be out of reach of children.
3 - Position the appliance at a height of 1.5 m from the ground to the top grill.
4 - Do not position the appliance in places of transit or narrow corridors to avoid it being knocked.
5 - Check that the appliance is complete and undamaged (if in doubt, contact a service centre).
7 - Plug the power cable (l) into the socket.
8 - Place the ON/OFF switch (H) at the back of the appliance in the "l" position.
9 - After about 2 minutes, the appliance is at the correct temperature to make coffee.
To clean the internal circuit, it is good practice to empty and fill the boiler a number of times and throw away the resulting water and coffee.
N.B. CHECK THAT THE POWER LINE COMPLIES WITH THE CHARACTERISTICS SPECIFIED ON THE RATING PLATE.

Connecting the water circuit

1) The appliance must be fed with cold water only.
2) If the mains pressure is higher than 6 bars, you must install a pressure regulator with 6 bars maximum output pressure.
3) Connect the drain hose to the drip tray, avoiding excessively tight curves and sloping the hose appropriately to facilitate the water flow.
4) Connect the 3/8" hose to the mains water supply, then to the water softener and the appliance.
N.B. The water softener is indispensable for correct operation of the appliance, to optimise coffee delivery in the cup and to extend the working life
of components as it purifies the water of limescale and the residues which would otherwise shorten their life.
Failure to follow these instructions absolves the company of all liability.
Before connecting the pump fill tube, open the tap and run the water through the water softener for about two minutes to eliminate possible dirt in
the circuit.
Keypad
KRGR1: Group 1 heating enabling/disabling key
KEGR1: Group 1 coffee delivery enabling/disabling key (ON/OFF)
KRGR2: Group 2 heating enabling/disabling key
KEGR2: Group 2 coffee delivery enabling/disabling key (ON/OFF)
KPL Key not in use (to be used for appliance PRESET only)
KRCV Steam boiler heating enabling/disabling key
LRGR1: Group 1 heating indicator LED
LEGR1: Group 1 coffee delivery indicator LED
LRGR2: Group 2 heating indicator LED
LEGR2: Group 2 coffee delivery indicator LED
LPL: Power indicator (always on when the appliance is powered up)
LRCV: Steam boiler heating indicator LED

Preliminary checks

Before using the appliance, make sure that:
- The power cable is plugged into the mains socket
- The fill hose is connected correctly to the mains water supply, there are no leaks and the water is open.
- The drain hose is positioned in accordance with the above instructions.
With the steam tap (B) open, place the ON/OFF switch (H) in the ON position and wait for the water in the boiler to reach the maximum level
established by the electronic control unit.
- Press the KRCV key to begin heating the steam boiler.
INSTALLATION
USE
16