Display; The Buttons - Unold 68125 Mode D'emploi

DISPLAY

BASIC SETTING:
As soon as the appliance is plugged into the electrical
outlet, and the appliance is switched on via the ON/OFF
switch, the display shows 2:40. Program 1 (Basic) is dis-
played and the light degree of browning is displayed.
During operation, the program status is indicated both by
the time countdown and the symbols on the display.
The following messages on the display indicate an error:

THE BUTTONS

On/Off-Switch
To switch the appliance on or off. This switch is located at
the lower side of the back of the housing. If you don't use
the appliance, you should always switch it off in order to
interrupt the power supply and then take the plug out of
the receptacle.
The programs can only be selected and started when the
appliance has been switched on.
START/STOP button
This button is used to start and stop the program. With the
START/STOP button you can cancel the program at any
time. For safety reasons, this button responds with a slight
delay; therefore, keep the button depressed for approx. 3
seconds. The start position of the Basic program appears in
the display. If you want to use a different program, select
the appropriate program with the Menu button.
MENU
The Menu button is used to select the individual programs,
which are described in detail in the „Program Sequence"
table. The number corresponding to the program appears
on the display to indicate the selected program. Use the
programs as described below:
Program Program
number name
1 BASIS
BASIC
2 WEISSBROT
WHITE
BREAD
3 VOLLKORN
WHOLE
GRAIN
4 SCHNELL
FAST
5 HEFE-
KUCHEN
YEAST CAKE
36
Use
The standard program for all
breads, such as white breads
and multi-grain breads
For especially light white
breads with longer rising
times
For whole-grain breads
For faster baking of white
and multi-grain breads
For preparing sweet yeast
dough
HHH or LLL: This message indicates a defect in the tempe-
rature sensor. Please have the appliance inspected by our
service department.
E E0 and E E1:
If this appears after pressing the START/STOP button the
appliance is still too hot from the last baking cycle. Open
the lid and allow the appliance to cool for another 10 to
20 minutes.
Program Program
number name
6 ULTRA-
SCHNELL
ULTRA-FAST
7 TEIG
DOUGH
8 KONFITÜRE
JAM
9 BACK-
PULVER
BAKING
POWDER
10 TOASTBROT
TOAST
11 BACKEN
BAKE
12 EIGEN-
PROGRAMM
USER
PROGRAM
Copyright UNOLD AG | www.unold.de
Use
For all level I recipes that are
baked in the programs Basic,
White Bread, Toast bread or
Fast. The dough rises for a
significantly shorter period
of time in the Ultra-Fast pro-
gram and consequently the
breads are more compact
and not as loose. A time pre-
select is not possible. Use
lukewarm liquids with this
program.
For preparing dough, without
bake function
For making jam and marma-
lade
To make jam you should
purchase a second baking
pan which is used only for
jam.
For baked goods baked with
baking powder, such as bat-
ter cakes
For preparing bread
toasting
For baking of yeast or batter
dough that has been pre-
pared separately (either by
hand or in the DOUGH pro-
gram). This program is not
suitable for pie dough or
choux pastry dough, etc.
Individual adjustment of the
program phases
for