Replacing Lamps - Elica ILLUSION Prescriptions De Montage Et Mode D'emploi

carry out filter maintenance.
Note: The filter saturation signal is visible for a few seconds when
the hood is switched on; within this time, the saturation
indicator lights must be reset.
Flashing Green LED: carry out maintenance on the grease
filter.
Red flashing LED: carry out maintenance on the charcoal
filter (only for hoods operating in "Filtration Version").
Note: Run the "RESET FILTRES" command via the remote
control.
Activating/deactivating the filter saturation indicator light
Note: Run the procedure with the hood switched off. The
charcoal filter saturation indicator light is usually deactivated.
If no control is given within maximum 10 sec, the hood
automatically exits this function, at any time, and returns to
the previous state.
Press and hold the B+C keys (Simultaneously) to enter the
setup menu:
Briefly press button C to select the filter to be set up:
Grease filter:Green
Charcoal filter: Red
Briefly press button B to activate (the 2nd LED flashing) or
deactivate (2nd LED off).
Note: the LEDs light up for a limited number of seconds after
which they turn off to indicate that the indicator light has been
activated (or deactivated).
The device can also be used in combination with a Window
sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use in
EXTRACTOR mode), air extraction will stop working each time the
window in the room, on which the KIT is applied, is closed.
- The KIT must be electrically connected to the device by
qualified and specialised technical personnel.
- The KIT must be separately certified in accordance with
the safety standards relative to the component and its
use with the device. Installation must be carried out in
accordance with current regulations for domestic
systems.
CAUTION:
- the wiring of the KIT to be connected to the device must
be part of a certified safety extra low voltage (SELV)
circuit.
- the manufacturer of this device declines all liability for
any inconveniences, damage, fires caused by defects
and/or problems associated with malfunction and/or
incorrect installation of the KIT.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid detergent.
DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Panel
Fig. 3-17
The panel for perimeter suction should always be left closed and
should only be opened in case of maintenance interventions (eg
cleaning or replacing filters).
Grease filter
Fig. 3-17
Traps cooking grease particles.
This must be cleaned once a month (or when the filter saturation
indication system – if envisaged on the model in possession –
indicates this necessity) using non aggressive detergents, either
by hand or in the dishwasher, which must be set to a low
temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed once every two months using
hot water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then remove
the mattress located inside the plastic frame and put it in the oven
for 10 minutes at 100° C to dry completely. Replace the mattress
every 3 years and when the cloth is damaged.

Replacing lamps

The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
21