Orla CDP 10 Notice D'utilisation page 8

TOUCH SENSE
Just like an acoustic piano, your instrument has an 88 note keyboard with velocity control. This
means the level of the audio signal will be in proportion with the velocity of the key pressed. If you
play soft you will have a quiet sound, while if you play very hard you will have a much louder
sound .
The TOUCH SENSE button allows you to select 3 different touch sensitivity curves:
HARD - This setting requires the keys to be played quite hard to produce maximum loudness.
NORMAL - This setting produces standard keyboard response. This is the factory default mode.
SOFT - This setting allows maximum volume with light key pressure.
Select the Touch Sensitivity you desired by pressing the TOUCH SENSE button until the desired
Led is switched On. If no Led is switched On the keyboard will be set at NO TOUCH
SENSITIVITY.
At Power Up the NORMAL curve will be automatically switched ON.
When no Touch Sense Led is switched on, the keyboard will play without touch sensitivity.
The default value is 100 but it can be changed following this procedure:
- press the Touch Sense button and hold it. The display shows:
- using the (/\) and (\/) DATA buttons it is possible to change the response from 0 to 127.
TRANSPOSE
The natural pitch of the instrument is C but can be modified as follows:
- press and hold the TRANSPOSE button in the FUNCTIONS section.
- The display will show:
100
C
8