Vortice MICROSOL V0 Notice D'emploi Et D'entretien page 7

Masquer les pouces Voir aussi pour MICROSOL V0:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Caution:
this symbol indicates precautions that must be taken to avoid damaging the appliance.
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not insert any objects into the appliance.
• Make sure that the door protecting the controls is
closed properly after making any adjustments.
• Check the appliance for damage at regular intervals.
If you detect any damage, do not use the appliance,
but contact Vortice immediately.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately.
Ensure that only genuine original Vortice spares are
used for any repairs.
• The appliance must be properly connected to an
electrical system in compliance with applicable
regulations, and must be equipped with an efficient
earthing system. If in doubt, have a qualified
electrician perform a thorough check.
• Connect the appliance to the electrical power
supply only if the supply system is able to provide
the maximum electrical power required by the
appliance (data plate fig. 6). If it cannot do so,
arrange for a qualified electrician to make the
necessary modifications.
• Never position the appliance directly under a power
socket.
* (or an authorised Service Centre if you live outside the UK or Ireland)
• When positioning the appliance, always observe the
minimum distances from walls and surrounding
objects as shown in figs. 4-5.
• Install the appliance in an upright position only, as
shown in figs. 4-5.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function
correctly; b) before cleaning the outside of the
appliance, c) if the appliance is not to be used for
any length of time.
The appliance must be
installed by a professionally
qualified electrician.
A multi-pole switch must be
used to install the appliance.
The contact opening gap must
be no less than 3 mm.
WARNING
• Do not cover the appliance in order to
prevent dangerous overheating.
• Keep the appliance's intake and outlet
grilles free and uncovered.
EN
7

Publicité

Table des Matières
loading

Table des Matières