Drive Belts - Husqvarna ST 324 Manuel D'utilisation

To replace the scraper bar
1. Put the scraper bar (A) in a reversed position when it
is worn to the edge of the housing.
2. Replace the scraper bar if it is worn on both sides or
if it is damaged.

Drive belts

WARNING: The v-belts on your product are
of special construction and should be
replaced by original equipment manufacturer
(OEM) belts available from your nearest
service center. Using other than OEM belts
can cause personal injury or damage to the
product.
WARNING: The belt replacement requires
separation of the product. While separating
the auger housing from the frame, it is
important that an assistant stands in the
operating position and holds the product
handles. Serious personal injury and/or
damage to the product could occur if the
product falls during the belt replacement
process.
Note: The auger and traction drive belts are not
adjustable. Replace the belts if they are damaged or
begin to slip from wear. It is recommended to have the
belts replaced by a qualified service center.
Note: It is recommended to replace the drive belt and
auger belt at the same time.
To prepare for replacement of the belts
1. Remove the fuel from the fuel tank.
18
2. Loosen the lock nut (A) that secures the chute
A
3. Loosen the two screws (A) that secure the belt cover
To remove the drive belt
1. Remove the auger belt. See
rotator head (B) to the mounting bracket (C) to
remove the discharge chute.
(B) to the frame (C) and remove the belt cover.
C
belt on page 19 .
B
A
C
A
B
To remove the auger
633 - 005 - 17.12.2019