Fitting Of The Active Edge Profiles - schmersal SMS 3 Instructions De Montage Et De Câblage

5. Installation
5.2.3 Fitting of the active
edge profiles
Place the active edge profiles
across the space between tactile
mats and along the mat edges.
Route the mat cables and mark
the active edge profile where the
cable will exit. Notch the active
edge profile, if needed for the
cable exits. Remove burrs and
sharp edges to avoid damaging
the cable(s).
Use the active edge profile as a
template. Start the anchor holes
on the floor by drilling (depth
approximately 5 mm). Do end
holes first.
Remove the active edge profiles
and drill the anchor holes to a
depth of about 25 mm. Insert the
screw anchors into holes.
Clean the floor area of the active
edge profile and reposition the
active edge profiles.
Moisten the screws with glue. In-
sert and tighten screws into an-
chors until the screw head is
about 1 mm below the surface of
the active edge profile.
Be careful not to damage mat ca-
bles.
When installing mat edges with
the active edge profiles, please be
careful not to activate the tactile
mats by tightening the screws too
much.
Fastening the Edge covers
(optional)
Position the active edge profiles,
so that the edge covers overlap a
min. of 10 mm and a max. of 25
mm.
Place the edge cover over the po-
sitioned active edge profiles. Drill
and fasten the edge cover as des-
cribed above.
20
Fig. 5: active edge profile
4,8
32
84
Fig. 6: dimensions of active edge profile (in mm)
Fig. 7: edge cover
6,3
Fig. 8: dimensions of the edge cover
4,8
15,8
8,4