Vortice CA WE Notice D'emploi Et D'entretien page 10

ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not rest objects on the device.
• Periodically check device conditions. If imperfections
are noted, do not use the unit and immediately
contact a Vortice authorised T echnical Assistance
Centre.
• Promptly contact a Vortice authorised Assistance
Centre in the event of unit malfunction and/or failure
and request the use of original Vortice spare parts for
any repairs.
• If the unit falls or receives a strong blow, immediately
have it inspected at a Vortice authorised T echnical
Assistance Centre.
• Only connect the device to the mains supply/
electrical outlet if plant/outlet capacity is suitable for
its maximum power. If otherwise, immediately seek
assistance from a professionally qualified person.
• Switch off the main switch on the system when: a) a
malfunction is detected, b) you decide to perform
external cleaning maintenance, c) when you decide
not to use the device for prolonged periods.
• It is essential to ensure that sufficient air re-enters
the room, in order to guarantee product operation. If
a combustion-powered, non air-tight device is
installed in the room (water heater, methane stove,
etc.), please ensure that air re-entry also guarantees
the perfect combustion of said device.
• The unit cannot be used as an activator for water
heaters, stoves, etc. nor should it discharge into hot
air ducts.
• The unit must be correctly connected to an effective
earthing system as foreseen by current electrical
safety regulations. If doubts should arise, request
careful inspection by qualified personnel.
• The unit must discharge directly outside.
• The air flow to convey (or fumes) must be clean (or
rather free of grease, soot, chemical and corrosive
substances or explosive and flammable mixtures).
• Never cover or obstruct the unit delivery grille to
ensure optimal air passage.
• The electrical specifications correspond to the ones
on the data label A (fig.A).
An omnipolar switch with a
•
contact opening distance of 3
mm or higher
provided
enabling
disconnection under overvoltage
category III conditions.
Products equipped with single-
•
phase wiring
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
kind of modification shall be
considered
10
should
for installation,
complete
(M) engines
as product
tampering and shall nullify the
relative warranty.
No specific
•
necessary
operate at nominal frequencies
without a preliminary setting.
• Thermal protection devices:
- Manual reset thermal protector
The following models are equipped with a manual
reset thermal protector
If the thermal protector is triggered, please contact
qualified personnel or Vortice authorised
Technical Assistance Centre.
If the problem persists after the reset
operation, check the electrical system to which the
unit is connected. In this case, please contact a
Vortice authorised Technical Assistance Centre or
professionally qualified personnel.
be
adjustment
as the devices
is