Henry Schein MD300C63 Mode D'emploi page 9

5. Dimension: Length: 58mm
6. Environment Requirements: Operation Temperature: 5°-40° Storage Temperature: -20°55°
Ambient Temperature: <80% in operation, no condensation.
7. Measurement Performance in Low Perfusion Condition:
Required the test equipment (BIO-TEK INDEX Pulse Oximeter tester) the pulse wave is available without failure
when the simulation pulse wave amplitude is at 0.6%.
8. Interference Resistance Capacity against Ambient Light: Device works normally when mixed noise pro-
duced by BIO-TEK INDEX Pulse Oximeter tester.
Guidance and manufacture's declaration – electromagnetic emissions- for all EQUIPMENT and SYSTEMS
The Pulse Oximeter is intended for use in the electromagnetic environment specified below.
The customer or the user of the Pulse Oximeter should assure that it is used in such an environment.
Emission test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11 Group 1
RF emission
CISPR 11 Class B
8
Width: 32mm Height: 37mm Weight: 33g (without batteries)
<93% in storage, no condensation.
Guidance and manufacture's declaration – electromagnetic emission
The Pulse Oximeter uses RF energy only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference in nearby electronic equipment.
The Pulse Oximeter is suitable for use in all establishments, including domestic establishments
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.