Henry Schein MD300C63 Mode D'emploi page 5

Operation Instructions
1 Install two AAA batteries correctly.
2 Nip the clamp as in diagram.
3 Fully insert one finger into rubber hole of the Oximeter.
fter turning on the Oximeter, each time you press the power switch, the Oximeter will switch to another
display mode. There are 6 display modes shown as follows:
When you press and hold the power switch for more than one second, the brightness of the Oximeter will be change
there are 10 levels on brightness; the default is level four.
4
4 Press the switch button once on the front panel.
5 Your finger and body should be steady during measuring.
6 Read corresponding data from display screen.