Henry Schein MD300C63 Mode D'emploi page 7

Battery Installation
1. To open cover - press the button and push in the direction of the arrow.
2. Put the two AAA batteries into battery cassette with correct polarities.
3. To close cover - push down and slide in the opposite direction of the arrow.
Notes:
• Battery polarities must be correctly installed.
Otherwise, damage might be caused to device.
• Please put in or remove batteries in carefully, or damage to the
device bracket may occur.
• Please remove batteries if the Oximeter will not be used for a long time.
Lanyard Installation
1. Insert thinner end of the strap through the loop.
2. Insert thicker end of the strap through the threaded end before pulling it tightly.
Maintenance and Storage
1. Replace the batteries when low voltage lamp is lit.
2. Clean surface of the fingertip Oximeter before each use/
3. Remove batteries if the Oximeter will not be operated for any length of time..
4. Store the product in a place with ambient temperature –20°55° and humidity <93% (no condensation).
5. It is recommended that the product should always be kept in a dry environment. A damp ambient will affect
the use or damage the product.
6. Please follow local government guidleines to dispose of used batteries.
6