Philips HD6157 Mode D'emploi page 10

EnglisH
10
cleaning
Let the oil or fat cool down for at least 4 hours before you clean or move the fryer.
Do not use any abrasive (liquid) cleaning agents or materials (e.g scouring pads) to clean the
appliance.
Do not immerse the fryer housing in water, as it contains electrical components and the heating
element.
1 Open the lid.
 Lift the lid off the appliance (Fig. 11).
 Lift the frying basket out of the appliance.
 Remove the condensed water container from the fryer and empty it (Fig. 12).
5 Lift the inner bowl out of the appliance and remove the oil or fat (Fig. 13).
 Clean the housing with a moist cloth (with some washing-up liquid) and/or kitchen paper.
7 Clean the lid with the filter, the basket, the inner bowl and the condensed water container in
hot water with some washing-up liquid or in the dishwasher.
8 Rinse the parts with fresh water and dry them thoroughly.
Make sure that all parts are dry before you fill the fryer with oil or fat.
Dishwasher-proof parts
- Lid
- Inner bowl
- Frying basket
- Condensed water container
storage
1 Put all parts back into/onto the fryer and close the lid.
 Roll up the cord, put it into the cord storage compartment and insert the cord in the cord
fixing facility (Fig. 14).
 Lift the fryer by its hand grips.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 15).
Removing the timer battery (HD6157 only)
- Batteries contain substances that may pollute the environment. Do not throw away batteries
with the normal household waste, but dispose of them at an official collection point for
batteries. Always remove the timer battery before you discard and hand in the appliance at an
official collection point.
1 Remove the timer panel with a small flat-blade screwdriver (Fig. 16).
 Remove the battery.