SAS LS6T-52HU Mode D'emploi page 80

GB
Sharpening the wedge
After using the log splitter for some time, sharpen the wedge of the log splitter
using a fine-toothed file and smooth any burrs or crushed area along the cutting
edge.
STORAGE
When you have finish working with your log splitter:
1. Disconnect the log splitter from the mains supply.
2. Tighten the oil yank cover / air bleeder,
3. Clean the unit down using a dry cloth.
4. Store in a dry and well-ventilated area.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE
Motor stops Overload protection device
starting disengaged to protect the log
splitter from being damaged
Log is improperly positioned
The sizes or hardness of the
log exceeds the capacity of the
machine
Wedge cutting edge is blunt
Fails to split
logs
Oil leaks
Unauthorized adjustment was
made on Max. Pressure
Limiting Screw. Lower max
pressure rating was set.
The log pusher Lack
moves jerkily, excessive air in the hydraulic
taking system
unfamiliar
noise or
vibrating a lot
of hydraulic oil
REMEDY SUGGESTED
Let motor cool down, and
push the button of the
overload protection device to
re-start the motor
Refer to "Log splitter
operation" section for perfect
log loading
Reduce the log size before
splitting it on the log splitter
Refer to "Sharpening wedge
"section to sharpen the
cutting edge.
Locate leak(s) and contact
the dealer
Contact the dealer
and Check oil level for possible oil
refilling. Contact the dealer.
18