SAS LS6T-52HU Mode D'emploi page 70

GB
UNPACKING
WARNING! To prevent accidental starting that could cause possible serious
personal injury, assemble all parts to your log splitter before connecting it to power
supply. Log splitter should never be connected to power supply when you are
assembling parts, making adjustment.
Carefully remove all parts from the carton and place the log splitter on a level work
surface of the height not less than 60cm. Separate and check against the list of
loose parts.
WARNING! If any parts are missing, do not operate this machine until the missing
parts are replaced. Failure to do so could result in serious personal injury.
 Do not discard the packing materials until you have carefully inspected the log
splitter, identified all parts, and satisfactorily operated your new log splitter.
Check all loose parts from the box with the list below. Assemble according to the
instruction on the following pages.
1 horizontal leg
2 front stand
3 back stand
4 horizontal shaft 2pcs
5 wheel
6 wheel shaft
7 wheel cover
8 circlip
9 Bolt M8*50
Bolt M8*45
10 Nut M8
11 Flat washer
12 Spring washer
1pcs
2pcs
2pcs
2pcs
2pcs
2pcs
8pcs
4pcs
6pcs
4pcs
12pcs
4pcs
8