Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
„Multidis SF"
2.6.2 Risk of injury from pressurised
components
f Only carry out work when the system is
depressurised
f Observe the permissible operating pres-
sures during operation.
2.6.3 Risk of burns due to an
uncontrolled escape of hot fluids
f Only carry out work on the heating/cooling
circuit or on the potable water circuit when
the system is depressurised.
f Check that the product is not leaking after
work is complete.
f Wear safety goggles.
2.6.4 Risk of burns due to hot
components and surfaces
f Allow the product to cool down before
working on it.
f Wear suitable protective clothing to avoid
unprotected contact with hot system com-
ponents and fittings.
2.6.5 Risk of injury in case of improper
work
Stored energies, angular components, protru-
sions and edges may cause injuries.
f Before starting work, make sure that there
is enough space.
f Handle open and sharp-edged compo-
nents with care.
f Make sure that the work place is tidy and
clean to avoid accidents.
2.6.6 Availability of the operating
instructions
Any person working on the product has to
read and apply these operating instructions
and all other valid documents (e.g. accessory
manuals).
The operating instructions must be available at
the installation location of the product.
f Hand these operating instructions and all
other relevant documents (e.g. accessory
manuals) over to the user.
140655280-V01.02.2020
Technical description
3.
Technical description
3.1 Construction
1
2
Illustr. 1: Construction of the flow distributor
(1)
Adapter G 1
(2)
Flow distributor
(3)
Regulating insert
(4)
Fill and drain valve G ¾
(5)
Connection nipple G ¾ male thread
(cone "Euro" according to DIN EN
16313)
1
2
Illustr. 2: Construction of the return collector
(1)
Adapter G 1
(2)
Return collector
(3)
Valve insert
3
4
5
3
4
5
6
19
Publicité
Chapitres
Table des Matières
