Instructions To The Owner; Assembly Instruction; Safety Instructions; Program Mode - Hedson IRT 4-1 PcAuto Mode D'emploi

3.

Instructions to the owner

The owner of the dryer must produce clear operating
instructions, adapted to local site conditions, and make
these available to all users who have to observe these
operating instructions.
This appliance is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their
safety.
Dispose of used items at the nearest environmental pro-
tection facility for recycling.
For safety reasons the infrared dryer must be supplied by
recommended maximum fuse, see tables in chapter 2.2.
4.

Safety instructions

The mobile dryer must not be exposed to paint fog,
sanding dust or solvents, due to fire hazard. Furthermore,
this will reduce the lifetime of the dryer. Allow for suffi-
cient cooling time of the dryer. The distance to the object
that is to be dried must be sufficient. Otherwise there is
risk for fire or explosion! Keep all flammable materials in
a sufficient distance from the hot surfaces of the dryer.
4.1 Hazards
Tilting
The risk for tilting increases when the arm is located in an
upright position. Turning both cassettes to one side also
increases the risk for tilting.
Fire and explosion
Do not store, prepare or use solvent-containing materials
within a 5 m/16 feet radius of the mobile dryer. Flam-
mable materials should not be placed close to a drying
device in use.
With the temperature control turned off, the temperature
might raise quickly and the risk for fire increases, espe-
cially if you have a distance less than 60 cm/24" to the
object. Never direct the cassette towards highly combus-
tible materials.
Electrical equipment
CAUTION! Disconnect all power supplies before open-
ing panel.
The mobile dryer is operated with high electrical voltage,
which can be highly dangerous. Before accessing live
parts, remove the main connector from the wall socket.
Only professional electricians may have direct access to
the electrical components.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING !
Intensive heat radiation. Hands, face and other
parts of the body should be exposed as little
as possible to the heat radiation.
713687 rev 10
5.

Assembly instruction

See separate document for detailed instructions.
For mobile dryers:
713847 IRT Pc Mobile Assembly Manual
For rail systems:
713683 IRT 3-20_4-20 Rail System Assembly Instruction
6. Basic instruction for operation
6.1 Keyboard
Software defined button
Confirmation choices
Start
Stop
Cassettes in use
(one or two)
6.2 Display
Active program
Flash off – active
Full bake – inactive
Confirmation choices
6.3

Program mode

This mode is for your everyday use. It helps you run the
dryer with preinstalled programs and edit program set-
tings.
To enter the program mode, turn the main switch on.
When you start the dryer, an information screen will
appear for two seconds. By pressing the confirmation
or cancellation button this information will show until
released. The diagram shows cassette filter usage and
notifies when it's time to change filter. To replace filter
see chapter "11.1 Filter replacement".
6.4 Settings mode
The Settings mode enables you to change advanced sys-
tem parameters. Thanks to our advanced control system
in this mobile dryer there are many settings that can be
altered. This is normally not a part of the everyday usage.
To enter the settings mode press both arrow keys when
you turn the main switch to position 1.
For further information see Chapter 9.
EN
Software defined button
Cancellation choices
Enter
Temperature control
(on/off)
One cassette active
Temperature reading
Cancellation choices
5 5