Free Warning Label Replacement - DeWalt DW217 Guide D'utilisation

Drilling in Wood
Holes in wood can be made with the same twist drills used for metal.
These bits may overheat unless pulled out frequently to clear chips
from the flutes. For larger holes, use power drill wood bits. Work that
is apt to splinter should be backed up with a block of wood.
Drilling in Masonry
Use carbide tipped masonry bits at low speeds. Keep an even force
on the drill but not so much that you crack the brittle materials. A
smooth, even flow of dust indicates the proper drilling rate.
Side Handle
A side handle may be supplied with your drill. Side handles are includ-
ed with these drills: DW231, DW235G, DW235-220, DW236, DW238,
DW239, DW245, DW246, DW248, DW249. The side handle clamps
to the front of the gear case and can be rotated 360 degrees to permit
right or left hand use.
CAUTION: If a side handle is included with your drill, always use it
and hold the drill with both hands.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liq-
uid get inside the tool; never immerse any part of the tool into a liquid.
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
Accessories
Recommended accessories for use with your tool are available at extra
cost from your distributor or local service center. ACCESSORY MUST
BE RATED FOR USE AT SPEED EQUAL TO OR HIGHER THAN
NAMEPLATE R.P.M. OF TOOL WITH WHICH IT IS BEING USED.
If you need assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286 or call 1-800-4- D WALT (1-800-732-4441).
E
CAUTION: The use of any non-recommended accessory may be
hazardous.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materi-
E
als or workmanship for three years from the date of purchase. This
warranty does not cover part failure due to normal wear or tool abuse.
For further detail of warranty coverage and warranty repair informa-
tion, visit www.dewalt.com or call 1-800-4-D
This warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives
you specific legal rights and you may have other rights which vary in
certain states or provinces.
In addition to the warranty, D WALT tools are covered by our:
E
1 YEAR FREE SERVICE
D WALT will maintain the tool and replace worn parts caused by nor-
E
mal use, for free, any time during the first year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your
D WALT Power Tool, Laser, or Nailer for any reason, you can return it
E
within 90 days from the date of purchase with a receipt for a full refund
– no questions asked.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
5
WALT (1-800-433-9258).
E